- Ultra & Bright: 16pcs led and its brightness is up to 320lm. It’s approximately the same amount of light as you get with an incandescent light which power is 60watt.
- Invisible switch: The “on/off” hole was designed for waterproof reason. Just use the supplied key pin to insert the switch hole. When hearing the “click”, the lighting system is unlocked.
- Motion Sensor: Integrated the design of PIR motion sensor and night sensor, this solar sensor light will auto turn on dim light when in darkness or at night, and auto turn off when in daytime or bright area. It will enter into high light mode when people come and stay for 30s after motion stops and then turn to dim light to save energy.
- Long Working Time: Built-in 2200mAh replaceable 18650 lithium batteries, motion lights outdoor only needs 8 hours to be fully charged and can last for 12 hours working time. Let the solar panel get enough sunshine during the day and it will turn on automatically at night to act as a motion detector outdoor light.
- Protection Design: The circuit board is coated with 3-resisting lacquer, which is insulated, damp proof, shockproof, dustproof, corrosion proof, anti-aging and anti-creeping. The back side of the led solar lights outdoor is sealed without hollow so it can effectively isolate the water and air.
1.Solar panel: 0.48W, 17% efficiency
2.Li-ion battery: 2.96WH
3.LED power: 1W, 6000K to 6500K
4.Motion angle and distance: 120degrees, 10ft
6.Working mode: Automatically turn off after lighting around 20s
1.No dim mode, designed for home security and longer product life.
2.Integrated design of PIR motion sensor and night sensor.
3.Recharged by Sunlight and store power for overnight lighting.
4.Over 12 hours lighting time after 8 hours charged under ideal bright sunlight.
5.Waterproof IP64 and durable.
Two steps easy to check whether the light can work or not:
1. Unlock the product, charging the light by direct sunlight around 8 hrs.
2. Cover the solar panel with your hand, if the light is on, the product is working.
1.Unlock and activate the solar light
The internal battery is locked from factory for safety shipment, so users have to use supplied Key Pin to click the “on/off” Switch Hole and unlock the battery and lighting system.
2.How to Install the device?
Please use the supplied expansion pillar-hinge and screw to mount the device on pole or wall and anywhere outside you want for lighting.
3.Charging via solar panel
Please make sure that the product is installed southward so that it can receive good direct sunlight without any shelter.
4.Night sensor function
At night or in darkness, this light will auto turn bright once human movement is detected by the PIR motion sensor and turn off after lighting 30 seconds.
1.Please fully charge the device for 2 or 3 sunny days before first use.
2.Two modes: on/off. NO DIM MODE.
2 x Lifebee Solar Motion Sensor Light
4 x Expansion pillar-hinge
4 x Screw
2 x Key pin
2 x Manual